System Configuration; Cc-Link - Mitsubishi MELESEC-ST User Manual

3 SYSTEM CONFIGURATION

3 SYSTEM CONFIGURATION
3.1 System Configuration

3.1.1 CC-Link

This section explains a general system configuration when the system is connected to
CC-Link.
GX Developer
*1: Refer to the GX Configurator-ST Manual for the system configuration when GX Configurator is used.
To use the head module as a Ver.1 remote device station, consider and modify the
points of slice modules so that the extended cyclic setting is set to single.
According to the points of the mounted slice modules, the head module
automatically optimizes cyclic setting.
For details, refer to the MELSEC-ST CC-Link Head Module User's Manual.
3 - 1
Master
station
Terminal
resistor
Terminal
resistor
Remote
station
QC30R2, etc.
*1
GX Configurator-ST
POINT
REMARK
For the CC-Link cable wiring and bus terminators, refer to the MELSEC-ST CC-Link
Head Module User's Manual.
Remote Remote
station station
Repeater
MELSEC-ST
Remote
Remote device
station
station
MELSEC-ST system
ST1PSD
RUN ERR RUN ERR RUN ERR RUN ERR
SYS 11 21 11 21 11 21 31 41
AUX
.
RELEASE
RESET
MELSEC-ST
Terminal
resistor
Terminal
resistor
ST1PDD
RUN ERR RUN ERR RUN ERR
51 61 71 81 91 101 111 121 131 141 151 161
AUX
3 - 1
3