Base Module Selection - Mitsubishi MELESEC-ST User Manual

6 BASE MODULE

6.2 Base module selection

(1) Selection of base module corresponding to slice module
(2) Terminal block type selection
6 - 2
After selecting the slice module, select the base module that corresponds to that
slice module. Refer to Chapter 5 and 7 for the base module applied to each slice
module.
As the base modules, the 1-slot type (power distribution module, intelligent
function module, 2/4-point I/O module) and 8-slot width (16-point I/O module) are
available.
Carefully select the base module that corresponds to the slice module.
Two different terminal blocks are available for the base modules: spring clamp
type and screw clamp type.
In the system, the spring clamp type and screw clamp type cannot be used
together. Select either terminal block type.
MELSEC-ST
6
6 - 2