Table 12 Field Descriptions For Table Ipnetwrk For Eiu Datafill - Nortel DMS-100 User Manual

While table 12 provides all the information you need to datafill for EIUs,
complete information on table IPNETWRK is in DMS-100 Translations
Guide, 297-xxxx-350.

Table 12 Field descriptions for table IPNETWRK for EIU datafill

Field Subfield or
refinement
KEYREF
TAB_KEY
CMIPADDR
SUBNET
OPTION
WORD_EIU
EIU_RNG
PARMAREA
(Sheet 1 of 3)
Entry Explanation and action
refer to subfield Key reference. This field consists of
subfield TAB_KEY.
Table key. Enter data in the network
0 to 15
interfaces. You can enter a maximum
of 16 entries.
IP address with Computing module Internet Protocol.
four numbers address. Enter the Internet Protocol
from 0 to 255 (IP) address of the CM. Separate each
number in the address with a single
space. For example, 47 2 86 122 is
equivalent to an IP address of
47.2.86.122.
1 to 23 Internet Protocol network subnet range.
Enter the range of the IP network
subnet mask bit width. Entries outside
the range indicated for this field are
invalid.
refer to subfields Option. This field consists of subfields
WORD_EIU and EIU_RNG. You can
enter up to a maximum of two options. If
you enter less than two options, end the
entry with a $.
This field defines the default EIU used
for routing.
EIU or Ethernet interface unit . Enter EIU
EXTERNAL_ (Ethernet interface unit) or
ROUTER EXTERNAL_ROUTER.
0 to 750 Ethernet interface unit range. Enter the
number that is assigned to the EIU.
refer to subfields Parameter area. This optional field
consists of subfield PARM. You can
enter a maximum of 12 multiples of this
field. If you enter less than 12 multiples,
end the list of entries with a $.
DMS-100 Family EIU User Guide TELECOM12
Chapter 3: EIU datafill 75