EHN1550-S
EBN1540-S
Alarm IO PIN Assignment
Note that this function is only available for EHN1550-S.
Reset Button
Note that this function is only available for EHN1550-S.
The Reset Button can be used to restore the camera to factory default. When
the camera is powered up, press the Reset Button about 8 seconds to reboot the
camera.
3. Installation
3.1 EHN1550-S
1. Stick the supplied Mounting Sticker on the surface to mark the 4 screw
positions. Drill the 4 screw-depth holes on the surface and then push the
supplied 4 Screw Anchors into the screw holes. Optionally drill the bottom 2
Cable Holes if you want to run the cables through the surface.
LAN / PoE Cable
Power Cable (12VDC)
1
Alarm In
GND
2
3
COM
4
Alarm Out
Reset Button
Alarm Input / Output
Audio Input
Audio Output
LAN / PoE Cable
12VDC Power Input
3