Advertisement
3.2 EBN1540-S
1. Stick the Mounting Sticker on the surface to mark the 3 screw positions. Drill
3 screw-depth holes on the surface and then push the supplied 3 Screw
Anchors into the holes. Optionally drill a Cable Hole on the center if you want
to run the cables through the surface.
2. Twist the Outer Housing counterclockwise and then remove the Outer
Housing.
Twist Outer Housing counterclockwise
3. Before screwing the Camera Base to the surface, thread the cables either
from the side-cut of the Camera Base or through the surface.
4. Screw the Camera Base to the surface using the supplied 3 Screws.
Screw Position x 3
Optionally drill a Cable Hole if
you want to run the cables
through the surface.
Remove the Outer Housing
6
Advertisement
