Advertisement
5. Place the camera body back to the Camera Base and twist back the Outer
Housing. Do not twist the Outer Housing too tight as you will have to adjust
camera angles while viewing camera live view.
6. Connect the camera to the network using the supplied Cable Gland Kit. Please
refer to Step 6 in 3.1 EHN1550-S.
7. Connect the camera to power. You can either connect the camera to a 12VDC
power source or to a PoE switch using the PoE cable.
8. Access the camera live view. See 4. Accessing the Camera.
9. Adjust camera angles and then tightly twist back the Outer Housing.
4. Accessing the Camera
You can look up the IP address of the IP camera using the IP Utility (IPU)
program. Please download the IP Utility from
search: "IP Utility").
The default IP mode of the IP camera is DHCP. However, if there is no dynamic IP
address assigned to the device, its IP will switch to 192.168.0.10. By default, the
ID is admin and there is no password. Please input a password for the first-time
login.
5. Important Note for Motorized Lens Models
For motorized lens models (EHN1550-S), if you find the live
image out of focus, please try the instructions below:
1. Go to the Live page and open the Lens Control panel
(see image on the right).
2. Click the Restore button for the lens to restore to the
default position, and then click the Auto Focus button.
3. If the image is still out of focus, adjust the focus by
clicking the Focus "+" or "-" buttons.
EverFocus website
7
(key word
Advertisement
