Panel Mounting; Pom Mounting (Panel Mounting) - Siemens SIPLUS HCS Operating Instructions Manual

Installing/mounting
5.2 Installing the Power Output Module (POM)
5.2.2

Panel mounting

5.2.2.1

POM mounting (panel mounting)

Installing the Power Output Module (POM)
1. Predrill the holes in the rear panel for mounting.
The required hole spacing is shown in the diagram below.
2. Screw the POM into place on the panel with four screws (M5).
Image 5-2
Minimum spacing
Natural convection must be possible above and below the device. A clearance of 100 mm
must be observed in both cases.
38
POM4320: Position of the mounting holes
Operating Instructions, 11/2015, A5E35452705A/002
SIPLUS HCS4300