Application Planning; Shipping; Storage - Siemens SIPLUS HCS Operating Instructions Manual

Application planning

4.1

Shipping

Shipping
NOTICE
Damage to the device
The device can be damaged by inappropriate shipping. Transport the device, therefore,
only in the original packaging. This will give it the necessary protection against shock and
impact.
Lifting and carrying the power output module (POM)
NOTICE
Damage to the device
The power output module (POM) is connected to the busbar adapter with 3 leads.
Do not use these leads to lift or carry the POM.
4.2

Storage

It is absolutely essential that the device is stored in compliance with the storage conditions
as described in Chapter Technical data (Page 121). In the event of ingress of dirt or liquid
into the equipment, formation of condensation, damage or any other failures to comply with
the prescribed storage conditions, the equipment must not be commissioned until the correct
remedial procedure has been discussed with Siemens AG.
SIPLUS HCS4300
Operating Instructions, 11/2015, A5E35452705A/002
4
27