Furuno FAR-3320SW Installation Manual page 98

2. WIRING
8. Unfasten the three bolts circled in the figure below to remove the cable clamp (up-
per).
J8 J8
J5 J5
J3 J3
J9 J9
J6 J6
J11 J11
J4 J4
J7 J7
J10 J10
Unfasten this bolt to use Unfasten this bolt to use
the lower clamp holes. the lower clamp holes.
Unfasten these three bolts to remove the upper plate.
9. Disconnect the control unit cable from the processor unit, then connect the cable
assy (6TPSH-XH12X2-LxxSP1).
10. Set the shield part of cables under the cable clamp then tighten the cable clamp.
11. Attach the processor unit cover.
2-62
J12 J12
J14 J14
J13 J13
Clamp holes
(upper)
Clamp holes
(lower)
Lay shields of cables
under this clamp then
tighten the clamp.