Furuno FAR-3320SW Installation Manual page 45

5) Set the front cover supplied with the kit. Take care not to hit the heater ele-
ments on the chassis or radiator.
6) Coat two M5 screws (supplied) with marine sealant then use them to fasten
the base of the heater. Take care not to hit the heater elements on the chassis
or radiator. Fasten the installation materials shown below to each of the cover
bolts.
M5 screw coated with M5 screw coated with
marine sealant marine sealant
7) Attach the supplied earth label over the earth label currently attached near the
grounding terminal.
7. Position the cables so their armors lie beneath their respective cable clamp plates
in the cable entrance. Fasten the plates.
8. Close the cable entrance cover as shown in the figure below.
Coat this part of gasket
with marine sealant.
9. Connect the performance monitor connector (J807) to the RF-TB Board.
10. Check that the gasket on the front and rear covers is seated properly, then
close the covers. Be careful not to hit the heater elements on the chassis or radi-
ator. The torque for the fixing bolts is 10.0 N•m.
Fixing Fixing
Grounding Grounding
Earth
label
Cable entrance
cover
Marine
sealant
Close cover then coat screw
heads with marine sealant.
2. WIRING
M5 screw M5 screw
Cover bolt Cover bolt
shaft shaft
terminal terminal
2-9