Furuno FAR-3320SW Installation Manual page 86

2. WIRING
Connection
J2 J2
Note: The cable shield must lie in the cable clamp.
Note: The cable shield must lie in the cable clamp.p.
Input method (MC-3010A only)
Select the method of the analog data input, power voltage or power current.
Note 1: The input must not exceed the range of the input voltage, to prevent malfunc-
tion.
-Setting for voltage input: -10V to +10V or 0 to 10V (depending on the setting)
-Setting for contact input: Voltage 4mA to 20mA
Note 2: When changing the input method, turn off the MC-3010A and on again to put
change in effect.
2-50
For TTYCSLA cables, pass the drain wire
through shrink tubing, then attach these crimp-
on lugs and screws to connect drain wires to chassis.
J5 J5
J4 J4
J3 J3
J1 J1
TTYCS-1/ TTYCS-1/
TTYCSLA-1 TTYCSLA-1
MC1.5-W-L cable MC1.5-W-L cable
J6 J6
J4 J4
J5 J5
J2 J2 J3 J3
J1 J1
MC1.5-W-L cable MC1.5-W-L cable
MC-3020D/3030D
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
IV-1.25sq. (Local supply) IV-1.25sq. (Local supply)
MPYC-12 MPYC-12