Furuno FAR-3320SW Installation Manual page 75

10. Connect the shield wires of the antenna cable and serial cable for processor unit.
11. Reattach the cable clamp assembly.
12. Remove the connector cover for the power cable (2 places).
Connector cover of power cable
13. Fabricate the power cable (DPYC-2.5) as shown below.
Vinyl tape
Armor
14. Pull up the plastic cover and connect the power cable.
15. Remount the connector cover for the power cable.
16. Reattach the cover of the power supply unit.
Grounding point (for antenna cable) Grounding point (for antenna cable)
Grounding point Grounding point
(for serial cable for processor unit) (for serial cable for processor unit)
Sheath (Clamp here.) Sheath (Clamp here.)
25
35
30
Plastic cover
FV2-4
2. WIRING
2-39