Furuno FAR-3320SW Installation Manual page 29

1. INSTALLATION
1.4.2 Flush mounting
Use the applicable optional flush mount kit to install the control unit in a console panel.
1. Prepare a cutout in the location as shown in the figure as below.
170+2
170+2
110+2
388+2
For RCU-025
For RCU-026
2. Set the control unit to the cutout.
3. Attach the mounting plate to the control unit with four screws from the rear side.
4. Screw the wing screw to each mounting plate and then insert hex. bolt to each
wing screw.
5. Fasten each wing screw and then fasten the hex. nuts as shown in figure below.
RCU-026 RCU-025
Side view of control units
1-15