Table of Contents
Advertisement
2.4
Processor Unit
Note: The interface ports approved for interconnecting navigation equipment are
shown in the figure below. For details, see section 2.4.3 "How to select the serial input/
output format".
Top view of EC-3000
2.4.1
How to connect cables to terminals in the processor unit
Use screws (M3×6, supplied) to attach the wiring plate 1 and wiring plate 2 to the pro-
cessor unit. Connect the cables shown below to the connectors at the front of the pro-
cessor unit. Bind cables to the appropriate fixing metal with the cable ties (supplied).
For the cables from the monitor unit, DSUB9P-X2-L5/10M) and ground wire, connect
them to the processor unit directly (without fixing to a wiring plate). Tighten the fixing
screws on these connectors to prevent disconnection from the processor unit.
Note: Connect the cables so that they do not interfere with the opening or closing of
the DVD tray.
OK
J8
J8
J8
J5
J5
J5
J3
J3
J3
J12
J12
J12
J11
J11
J11
J6
J6
J6
J9
J9
J9
J4
J4
J4
J13
J13
J13
J10
J10
J10
J7
J7
J7
UP
J3, J4
For IEC 61162-2 or
IEC 61162-1
J14
J14
J14
J5, J6, J7, J8, J9, J10
For IEC 61162-1
2. WIRING
2-25
Advertisement
Table of Contents
