Setup And Adjustments; Box Width Adjustment; Box Height Adjustment; Changing The Tape Leg Length - 3M -Matic 700r3 Instructions And Parts List

11 - SET UP AND ADJUSTMENTS

11.1 Box Width Adjustment

Boxes are automatically centered by the Side Guides
(Figure 11-1). The Side Guides are
triggered by the Centering Guide Switch which is
located on the machine bed. Side Guides air
pressure adjustments can be made using the
Centering Guide Air Pressure Regulator
(See Figure 9-8).

11.2 Box Height Adjustment

Box Height is automatically determined when the Up-
per Drive Assembly Actuator Switch is engaged which
is located on the front of the Upper Drive
Assembly (See Figure 11-2).
The Upper Drive air pressure adjustments can
be made using the Centering Guide Air Pressure
Regulator (See Figure 9-8).
11.3 Adjustment of Top Flap Compression
Rollers (Not Applicable to this Machine)

11.4 Changing the Tape Leg Length

Taping heads are preset to apply 70mm [2.75 inches]
long tape legs. To change tape leg length to 50mm
[2.0 inches], refer to Instructions below and also to
Manual 2, "Removing Taping Heads Procedure -
Changing the Tape Leg Length".
With upper drive assembly in raised position:
1. Remove tape from upper taping head.
2. Pivot up the clamp that secures the upper taping
head.
3. Hold upper taping head applying and buffi ng arms
from under upper assembly, slide head forward
and down to remove. See Figure 11-3.
4. Lift the lower taping head, shown in Figure 11-4,
straight up to remove it from the case sealer bed.
5. Refer to Section II, "Adjustments – Changing
Tape Leg Length," for taping head setup.
6. Replace taping heads reverse of disassembly.
Turn on air supply and electric power, unlatch
upper drive assembly and allow it to return to
its rest position.
Figure 11-1
700r3-NA
Figure 11-2
Figure 11-3 – Remove Upper Taping Head
Figure 11-4 – Remove Lower Taping Head
37
Upper Drive
Actuator Switch
2012 January