Table of Contents
Advertisement
Burst
In Burst mode a waveform is repeated a predefined number of times or until the Trigger signal is at High
Level depending on the selected Burst Type. This Run Mode is available for all waveforms except the DC
level.
Marker Out behaviour in Burst Run Mode
In this Run Mode, the Marker Out generates a pulse with a duration equal to the duration of the burst
sequence or to the gate time duration (time when the Trigger signal is at High level).
Burst Mode
The burst mode allows to define the behaviour of the instrument after the Trigger reception. Touching
the "Mode" button the following menu opens and it is possible to select the burst type.
•
1 Cycles: the instrument waits for a Trigger. When the trigger is detected it generates one time
the carrier waveform then it stops and waits for the next Trigger.
•
N-Cycles: the instrument waits for a Trigger. When the trigger is detected it generates N times
the carrier waveform then it stops and waits for the next Trigger. The number of N cycles to
generate is defined by the Number of Cycles parameter.
Operator's Manual Simple AFG Application
48
Advertisement
Table of Contents
