Environmental Compliance - Teledyne T3AWG2152 Operator's Manual

• Mains Supply Connector: Overvoltage Category II, instrument intended to be supplied from the
building wiring at utilization points (socket outlets and similar).
• Measuring Circuit Terminals: No rated measurement category. Terminals not intended to be
connected directly to the mains supply.
• Unit: Pollution Degree 2, operating environment where normally only dry, non-conductive pollution
occurs. Temporary conductivity caused by condensation should be expected.

Environmental Compliance

END-OF-LIFE HANDLING
The instrument is marked with this symbol to indicate that it complies with the applicable
European Union requirements to Directives 2012/19/EU and 2013/56/EU on Waste
Electrical and Electronic Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations that vary by country and
region. Many countries prohibit the disposal of waste electronic equipment in standard
waste receptacles.
RESTRICTION OF HAZARDOUS SUBSTANCES (RoHS)
This instrument and its accessories conform to the 2011/65/EU RoHS2 Directive.
Operator's Manual Simple AFG Application
932470 Rev1
65