Defining Bandwidth Settings - 3Com 2924-SFP User Manual

Defining
Bandwidth Settings
Egress Shaping Rates
Status — Defines the shaping status. The possible field values are:
■
Enable — Enables egress traffic shaping for the interface.
■
Disable — Disables egress traffic shaping for the interface.
■
CIR — Defines CIR as the interface shaping type. The possible field
■
range is 64-1,000,000,000 kbits per second.
CbS — Defines CbS as the interface shaping type. The possible field
■
range is 4096-16,769,020 bytes per second.
The Bandwidth Setup Page allows network managers to define the
bandwidth settings for a specified interface. Interface shaping can be
based on an interface and is determined by the lower specified value. The
interface shaping type is selected in the Bandwidth Setup Page.
The monitor user has no access to this page.
To configure Bandwidth Settings:
1 Click Policy > QoS General > Bandwidth > Setup. The Bandwidth
Setup Page opens:
Figure 84 Bandwidth Setup Page

Defining Bandwidth Settings

151