Subaru 2001 Legacy Owner's Manual page 72

8. Pull out one side of the lap-shoulder belt and place it over the
child's shoulder. Insert the tongue plate into the buckle until it clicks.
If both sides of the belt are pulled out, the belts will lock. If the belts
lock, allow them to fully retract to unlock the retractor. Then pull out
only one side of the belt.
9. Pull out the other side of lap-shoulder belt and place it over the
child's shoulder in a single motion. Insert the tongue plate into the
buckle until it clicks. Once the belt retracts even slightly, the ALR will
be activated and both belts will lock.
If the belt stops before the tongue reaches the buckle, allow both
belts to fully retract to unlock the retractor and then separately pull out
the belts and buckle them again.
10. Allow both belts to tighten snugly against the child's shoulders.
Because of the ALR function, the belts cannot be pulled out simulta-
neously from the retractor.
The color green must appear in the indicator window on each tongue
when buckled. If the color red appears in the window, the tongue is
not buckled.
WARNING
After inserting the tongue plates, make sure the tongue plates
and buckle are locked and that the lap-shoulder belts and crotch
belt are not twisted. If the restraint is used with the tongues and
buckle not locked and/or with the belts twisted, the risk or severi-
ty of injury to the child could increase in an accident.
CAUTION
If the child restraint belts do not function normally, contact your
authorized SUBARU dealer immediately.
Seat, seatbelt and SRS airbags
– CONTINUED –
1-49