Subaru 2001 Legacy Owner's Manual page 114

To unlock all doors (and the rear gate on the station wagon), briefly
press the "UNLOCK/DISARM" button a second time.
n Emergency disarming
If you cannot disarm the system using the transmitter (i.e. the trans-
mitter is lost, broken or the transmitter battery is too weak), you can
disarm the system without using the transmitter.
To disarm the system:
1. Unlock the door with the key and then open the door.
2. The alarm will sound.
3. Insert the key into the ignition switch and cycle it from the "LOCK"
to the "ON" position three (3) times within 5 seconds.
B Sounding a panic alarm
To activate the alarm, keep the "LOCK/ARM" button pressed for more
than two seconds.
To deactivate it, press the "LOCK/ARM" button or "UNLOCK/DISARM"
button.
The parking lights will also flash when the alarm is activated.
Unless a button on the remote is pressed, the alarm will be deacti-
vated after approximately 30 seconds.
B Valet mode
When you choose the valet mode, the security system does not oper-
ate. In valet mode, the remote transmitter is used only for locking and
unlocking the doors (and rear gate on the station wagon) and panic
activation.
To enter the valet mode, open the driver's door and keep the
"UNLOCK/DISARM" button depressed for more than two seconds.
The indicator light repeatedly flashes two times while the system is in
valet mode.
To exit valet mode, open the driver's door and keep the "UNLOCK/
DISARM" button pressed for more than two seconds. The indicator
will stop flashing.
2-16