Subaru 2001 Legacy Owner's Manual page 430

Hide thumbs Also See for 2001 Legacy:

Table of Contents

Maintenance and service

3. Using a Phillips screwdriver, remove the upper and lower screws

that secure the side cover of the rear combination light assembly.

4. Remove the bulb socket from the rear combination light assembly

by turning it counterclockwise.

5. Remove the bulb from the socket.

Turn signal light: Pull the bulb out of the socket.

Brake/tail light: Remove the bulb from the socket by pushing it and

turning it counterclockwise.

6. Install a new bulb in the socket.

7. Set the bulb holder into the rear combination light assembly and

turn it clockwise until it locks.

8. Fit the rear combination light assembly into the vehicle body and

tighten the nuts from the interior of the vehicle.

9. Reinstall the light bulb replacement service hole covers.

– CONTINUED –

Chapters

Table of Contents

2001 outback