Subaru 2001 Legacy Owner's Manual page 54

D Seatbelt pretensioner (Driver's side)
D Seatbelt pretensioner (Passenger's side)
D All related wiring
In the event of a malfunction indicated by any of following, the vehicle
should be taken promptly to your nearest SUBARU dealer to have the
system checked. Unless checked and repaired, the seatbelt preten-
sioners and airbags will not function reliably:
D Flashing or flickering of the indicator light.
D No illumination of the warning light when the ignition switch is
first turned to the "ON" position.
D Continuous illumination of the warning light.
D Illumination of the warning light while driving.
B System servicing
WARNING
D When discarding a seatbelt retractor assembly or scrapping
the entire car damaged by a collision, consult your SUBARU deal-
er.
D Tampering with or disconnecting the system's wiring could re-
sult in accidental activation of the seatbelt pretensioner and/or
airbag or could make the system inoperative, which may result in
serious injury. The wiring harnesses of the seatbelt pretensioner
and SRS airbag systems are covered with yellow insulation and
the connectors of the system are yellow for easy identification.
Do not use electrical test equipment on any circuit related to the
seatbelt pretensioner and airbag systems. For required servicing
of the seatbelt pretensioner, see your nearest SUBARU dealer.
CAUTION
The front sub sensors are located in both front fenders and the
airbag control module including the impact sensors is located
under the center console. If you need service or repair in those
areas or near the front seatbelt retractors, we recommend that
you have an authorized SUBARU dealer perform the work.
Seat, seatbelt and SRS airbags
– CONTINUED –
1-31