Subaru 2001 Legacy Owner's Manual page 208

B Stereo indicator
The stereo indicator "ST" will come on when an FM stereo broadcast
is received.
B Weather band button (WB)
3
Push the "WB" button when the radio is off to turn on the radio in
the weather band.
Press the "WB" button when the radio is on to select the weather
band.
B Manual tuning (TUNE)
n Manual tuning for AM and FM waveband
4
Push the tuning button marked "Y" to increase the tuning frequen-
cy and press the tuning button marked "B" to decrease it.
Each time the button is pressed, the frequency changes 10 KHz in the
AM waveband and 0.2 MHz in the FM waveband.
Constant pressure on the button causes a continuous change in the
frequency.
n Manual tuning for weather band
4
When weather band mode is selected, press the tuning button
marked "Y" to change the WB channel up and press the tuning but-
ton marked "B" to change the WB channel down. Each time the but-
ton is pressed, the WB channel changes to the next channel.
Constant pressure on the button causes a continuous change in the
channel.
B Automatic tuning (SCAN)
2
Press the "SCAN" button to change the radio to the SCAN mode. In
this mode, the radio scans through the radio band until a station is
found. The radio will stop at the station for five seconds while display-
ing the frequency, after which scanning will continue until the entire
band has been scanned from the low end to the high end.
Press the "SCAN" button again to cancel the SCAN mode and to stop
on any displayed frequency.
When the "SCAN" button is pressed for automatic tuning, stations are
scanned in the direction of low frequencies to high frequencies only.
5-22