Subaru 1998 Legacy Owner's Manual page 182

note volume level by turning the volume control knob. The control
function returns to volume control mode after about 5 seconds.
B Treble control
Treble volume control indication
Select the Treble control mode by pressing the "AUDIO" button. In the
treble control mode, the display shows the indication as shown.
The treble control has total of 11 volume levels (TRE. –5 for minimum,
TRE. 0 for middle, TRE. 5 for maximum). Choose desired treble vol-
ume level by turning the volume control knob. The control function re-
turns to volume control mode after about 5 seconds.
J Fader and balance control (FAD/BAL)
The volume control knob normally function as volume control. This knob
become the controls for Fader or Balance when you select the relevant
fader and balance control mode.
The "FAD/BAL" (fader and balance) button is used for selecting the fol-
lowing control modes:
– Fader control (Volume balance control between front and rear
speakers)
– Balance control (Volume balance control between right and left
speakers)
To change control modes: Each brief pushing the "FAD/BAL" button
changes control modes in the following sequence starting from fader
control mode. (When the radio is powered on, control mode is in the vol-
ume control.)
5-30
When the treble volume level is set
at the level –5
HB0348 HB0328