Qr-Coded Parameter Menu - Denso SE1-QB User Manual

11.2 QR-coded Parameter Menu

The beeper volume can be set by scanning the following QR Code symbol only. No "Start setting" or "End
setting" QR Code symbol required to be scanned.
Easy connection setup
To set the connection corresponding to the connected device, simply read the QR codes below.
(The connected device should be equipped with Bluetooth
Specification Ver. 2.1+EDR.)
The 1st connection waits for the connection from a connection target. With future connections, you can connect
by only pressing the trigger switch. (Only when connecting with the same device)
iOS (iPhone, iPad)
(HID Profile)
Windows PC, Android
(SPP Profile)
The beeper volume can be set by scanning the following QR Code symbol only. No "Start setting" or "End
setting" QR Code symbol required to be scanned.
Adjusting the beeper volume
Scanning this QR Code symbol cycles the beeper volume through High, Medium and Low. The factory default
is High.
®
module that is compatible with Bluetooth
Beeper volume
67
®
Android
(HID Profile)
Windows PC
(HID Profile)