Chapter 5 Scanning Control; Trigger Switch Control - Denso SE1-QB User Manual

Chapter 5 Scanning Control

Scanning is controlled by trigger switch control. (Section 5.1)

5.1 Trigger Switch Control

Pressing the trigger switch turns on the illumination LEDs and readies the scanner for scanning. The scanner supports the
following three trigger switch operating modes. Select the one that best meets your needs using the QR-coded parameter
menu or the configuration software (Scan Tune App).
(1) Auto-off mode
When the trigger switch is pressed, the scanner is brought to the Active state for approximately five seconds.
The scanner automatically returns to the Ready state when scanning is successfully completed, or after approximately five
seconds elapsed with the trigger switch pressed.
The scanner goes to the Ready state if the trigger switch is released before five seconds elapse.
(2) Momentary switching mode
The scanner is brought to the Active state only when the trigger switch is pressed, and returns to the Ready state when the
trigger switch is released.
(3) Alternate switching mode
The scanner alternates between the Active state and the Ready state every time the trigger switch is pressed.
Note:
• When you are setting parameters using the QR-coded parameter menu, the scanner is always in the auto-off
mode regardless of the trigger switch operating mode selected.
• Establishing the Bluetooth
the trigger switch control.
®
wireless link or selecting the "Scan w/ Bluetooth
®
link broken" parameter enables
15