Marker Beam; Normal Marker Mode; Marker-Off Mode; Marker-On Mode - Denso SE1-QB User Manual

2d code handy scanner

Table of Contents

8.3 Marker Beam

The red marker beam (LED lights in red) comes on to indicate the scanning area as a guide.

The marker provides a choice of the three modes — normal marker mode, marker-OFF mode and marker-ON mode — that

can be selected by using the QR-coded parameter menu or the configuration software (Scan Tune App).

When the trigger switch is in Auto-off mode:

The marker beam is turned on continuously by holding down the trigger switch.

When the scanner is ready (that is, within approx. five seconds from pressing the trigger switch or until completion of

scanning from that), the marker beam remains on. The marker beam turns off by pressing the trigger switch and leaving the

scanner in a ready state for approx. five seconds, by completion of scanning or by releasing the trigger switch.

When the trigger switch is in Momentary switching mode or Alternate switching mode:

In the Momentary switching mode, holding down the trigger switch turns on the marker beam continuously for approx. 30

seconds.

When the scanner is ready (that, while the trigger switch is pressed in the Momentary switching mode or when the scanner is

readied in the Alternate switching mode), the marker beam turns on continuously.

When the scanner is on standby (that, when the trigger switch is released in the Momentary switching mode or when the

scanner is set to standby in the Alternate switching mode), the marker beam turns off.

The marker beam will not come on under any conditions.

When the scanner switches to standby, the marker beam is turned on for approx. 30 seconds.

When it is ready to scan, the marker beam remains on.

When the scanner is ready to scan, the illumination LEDs are turned on.

The illumination LEDs provide the two choices—ON, OFF by using the configuration software (ScannerSetting_2D).

Table of Contents