Denso SE1-QB User Manual page 23

Scanner as Master
To configure the scanner as a master and the BA series communications adapter (or a commercially available Bluetooth
device) as a slave, follow the sample procedures given below and specify the slave's Bluetooth
scanner and slave device should be connected in a 1:1 configuration.
Using the BA series communications adapter (example)
(1) Use the scanner to scan the barcode (BA series communications adapter's Bluetooth
series communications adapter.
Wait for the scanner to configure itself as a master and establish a Bluetooth
communications adapter.
(2) Wait for the scanner to beep twice and the indicator LED to turn green (for 0.5 second), indicating a successful
connection.
The BA series communications adapter automatically selects the SPP profile to connect to the scanner. The BA
Note:
series communications adapter cannot be connected to the scanner by the HID profile.
Using a commercially available Bluetooth
(1) Confirm the device's Bluetooth
For instructions on how to confirm the Bluetooth
(2) With the configuration software (Scan Tune App)*, generate a "Bluetooth
®
Bluetooth address to the scanner.
When using a commercially available code generator, generate it in the following format.
(3) Set the profile to be used and the local device ID.
For setting the profile and local device ID, use the configuration software (Scan Tune App). (When the scanner leaves the
factory, the default settings for the profile and local device ID are "SPP profile" and "Unclassified device", respectively.)
(4) Use the scanner to scan the "Bluetooth
(5) Wait for the scanner as a master to establish a Bluetooth
(6) Wait for the scanner to beep twice and the indicator LED to turn green (for 0.5 second), indicating a successful
connection.
Note:
®
• Some Bluetooth devices that have not been connected even once sometimes cannot be connected as the master. If
this happens, use the QR-coded parameter menu "Easy connection setup". Use of "Easy connection setup" enables the
scanner to be connected as the slave only at the first connection. From connections after this, the scanner is connected
as the master.
• When the scanner is connected to a commercially available Bluetooth
connection sometimes does not complete until the COM port is opened on the device side after identification. Open
the COM port after identification is completed.
®
device (example)
®
address.
Code type
QR Code Model 1, 2
Code 128 Code Set A
(Note) XXXXXXXXXXXX should be a Bluetooth
®
Example: Bluetooth
ADDR000AF1234567
®
address" code.
®
address, refer to the instructions in the User's Manual for the device.
Data format
%%
ADDRXXXXXXXXXXXX %%
ADDRXXXXXXXXXXXX
address 000AF1234567
®
wireless link with the specified Bluetooth
10
®
address to the scanner. The
®
address) on the back of the BA
®
wireless link with the BA series
®
address" code that specifies the equipment's
®
address in hexadecimal.
®
device by the SPP profile, the wireless link
®
®
device.