Ice-O-Matic CIM2046 Technical & Service Manual page 61

ELEVATION SERIES CIM CUBERS EVAPORATOR REPLACEMENT
There are five screws holding both side walls on to the evaporator assembly. Remove them and the side
wall from the old assembly and reuse the screws to mount the new side walls to the new evaporator
plate assemblies.
Mounting Screw
locations for side
walls
Interior Right Wall
Exterior Right Wall
The left side walls from the old evaporators will be reused. Remove them from the old assemblies and
reattach them to the new evaporator. Reuse the screws from the old assemblies. Remove the old silicone
on the base where it interfaces with the evaporator. Add a new 3/8" bead of silicone to the corners and
flat face of the base before reinstalling new evaporator.
Once you have the side walls attached to the new evaporator. Reinstall the assembly in the reverse
order. When reinstalling screws into the base be sure to not exceed a torque of 30in‐lb to avoid striping
the base. Be sure to replace the filter dryer as well since it is an open system repair.
59