Ice-O-Matic CIM2046 Technical & Service Manual page 43

ELEVATION SERIES CIM CUBER
Splash Curtain
The Bridge Thickness on units under 400# production should be 3/16" while units over 400# pro‐
duction should be 1/8" thick when measured across the middle of the plate. Minor Adjustments
can be made to the bridge thickness by moving the Water Level Adjustment Arm of the Float
Housing up for a thicker bridge or down for a thinner bridge. This adjustment can be made at
any time during the freeze or defrost cycle and the results verified on the following cycle.
Sump
HIGH AND LOW FLOAT SWITCHES AND HOUSING
Thicker
Bridge
Thinner
Bridge
41