Ford 1996 Windstar Manual page 53

Route the tongue and webbing through the child seat
3.
according to the child seat manufacturer's instructions.
Insert the belt tongue into the proper buckle for the center
4.
seating position until you hear a snap and feel it latch. Make
sure the tongue is securely fastened to the buckle by pulling
on tongue.
Push down on the child seat while pulling on the loose end
5.
of the lap belt webbing to tighten the belt.
Before placing the child into the child seat, forcibly tilt the
6.
child seat from side to side and in forward directions to
ensure that the seat is held securely in place. If the child seat
moves excessively, repeat steps 5 through 6 or properly
install the child seat in a different seating position.
Attaching Safety Seats With Tether Straps
Some manufacturers make safety seats that include a tether
strap that goes over the back of the vehicle seat and attaches to
an anchoring point. Other manufacturers offer the tether strap
as an accessory. Contact the manufacturer of your child safety
seat for information about ordering a tether strap.
You can attach a tether strap to the front passenger or second
row seats by using the built-in tether anchors provided on the
back of the seats as described below.
Follow the child seat manufacturer's instructions to attach the
tether strap to the tether anchor.
Use only the tether attachment locations shown below.
The tether anchor may not perform properly if the wrong
mounting location is used.
50
RWARNING