Table of Contents
Advertisement
Using the "SCAN" function (Stereo Cassette Radio)
Press the "SCAN" button to enter the scan mode. The radio
will begin scanning up the frequency band, stopping on each
listenable station for approximately a five-second sampling.
This continues until you press the "SCAN" button a second
time. The display flashes "AM" or "FM."
Setting the station MEMORY PRESET buttons
Your radio is equipped with 5 station memory buttons.
These buttons can be used to select up to 5 preset AM
stations and 10 preset FM stations (5 in FM1 and 5 in FM2).
Follow the easy steps below to set these buttons to the desired
frequencies:
Select a band, then select a frequency.
1.
Press one of the memory buttons and hold the button until
2.
the sound returns. That station is now held in memory on
that button.
Follow the two steps above for each station memory preset
3.
button you want to set.
NOTE: If the vehicle's battery is disconnected, the clock and
station memory preset buttons (if programmed in auto
mode) will need to be reset.
Adjusting the tone balance and speaker output of your
radio
Increasing or decreasing bass response
Push the "AUDIO" button repeatedly until the display reads
"BASS." Push the right (+) side of the "VOLUME" button to
increase bass (more "lows"), and push the left (-) side to
decrease bass (less "lows").
Electronic Sound Systems
227
Hide quick links:
Advertisement
Table of Contents
