Ford 1996 Windstar Manual page 200

Using the "SCAN/TUNE" button to scan radio stations
Pressing the "SCAN/TUNE" button once enters the scan
mode (display will indicate "SCN"). Pushing the top a half
of the "SEEK" button will begin the scan mode up the
frequency band, stopping on each listenable station for
approximately five seconds. Pushing the bottom b half of
the "SEEK" button will begin the scan mode down the
frequency band, again stopping on each listenable station for
approximately five seconds.
To stop the scan mode on the presently sampled station
press the "SCAN/TUNE" button again.
Setting the station MEMORY PRESET buttons
Your radio is equipped with 5 station memory buttons.
These buttons can be used to select up to 5 preset AM
stations and 10 FM stations (5 in FM1 and 5 in FM2). Follow
the easy steps below to set these buttons to the desired
frequencies.
Select a band, then select a frequency.
1.
Press one of the memory buttons and hold the button until
2.
the sound returns. That station is now held in memory on
that button.
Follow the two steps above for each station memory preset
3.
button you want to set.
Using the Automatic Memory Load and Automatic
Memory Store features
NOTE: If no stations are in memory presets, you can activate
the feature by pressing and holding the "AUTO
PRESET" button for approximately three seconds.
Auto Memory Load sets all memory buttons in AM,
FM1 and FM2 sequentially by seeking out the first
five strong stations for the respective band and storing
them in memory buttons 1-5. (FM2 will store the
second set of strong stations from the FM band.)
198