Ford 1996 Windstar Manual page 203

When in the CD mode, push the "CLOCK" button to change
the display from elapsed time mode to track number mode to
clock mode. If the CD track selection is changed when you are
in the clock or elapsed time mode, the new track number will
be displayed for approximately ten seconds and then revert
back to the previous mode.
To set the clock, simultaneously press the "CLOCK" button and
either the bottom ( b ) half of the "SEEK" button to set hours,
or the top ( a ) half of the "SEEK" button to set minutes.
NOTE: The clock can be set with the radio and/or ignition on
or off.
Using the Controls on Your New Compact Disc Player
Your new Ford Compact Disc Player is capable of playing 12
cm or 8 cm discs, without an adapter! The Player operates when
the power is on and a disc is inserted (label side up). Handle
the disc by its edge only. (Be sure to read and follow all of the
care and cleaning instructions under How To Take Care of and
Clean Your CD Player and Discs.
NOTE: If after you insert a disc, the disc is ejected and
"ERROR" begins scrolling in the display, remove the
disc and reinsert it right side up (label side up).
The digital display on your CD player will either show the
track (selection) number or the elapsed time. (The display mode
can be selected by pressing the "CLOCK" button.) Indicators for
play ( a ), stop ( X ) and compression on ("C") are also in the
display. (These features are described later.)
Once a disc is inserted, operation of the CD player will override
that of the radio.
NOTE: The volume, bass, treble, balance and fader controls
on the radio are also used with the CD player. Refer
to earlier operating instructions on these controls.
Electronic Sound Systems
201