Panasonic KAIROS Operating Manual page 79

"Source Substitution" is typically used in order to replace a single source or even multiple sources from
a designated Auxbus (output). The function can be used, for example, to replace a "Helicopter" shot
with a regular wide-angle camera shot. It can also substitute a channel of character generator using an
international language instead of the local national language. There are various ways to utilize "Source
Substitution" also to avoid visual feedbacks when, for example, the "On-Air" camera is shooting the
"Video-wall" where "Main-PGM" is the selected source.
Picture 3.3.8.1.8
Opening the "Source" dialog for selection
"Substitution" dialog for selected source
Delete selected "Substitution"
Change order of appearance
Picture 3.3.8.1.10
Note: Once "Source Substitution" is enabled, Kairos will replace the selected crosspoints "on the fly"
according to the substitution "Table," regardless of which Layer might appear, and also which effect is
used to make them visible.
Ok = Confirm & close
Cancel = Abort dialog
When pressing the " add effect" button in the
lower right corner of the Aux menu, a pop-up
window appears (as in the Layer- or FxInputs
menu), enabling selection of additional effects
and adding them to the default effects list. Apart
from "Source Substitution," various other effects
are available.
Selecting "Source Substitution" will add the effect
to the list:
Delete effect from list
"Set" (edit) "Table" (list) for "Source Substitution"
Setting up a list for "Source Substitution" when
clicking on the "set..." button right next to "Table"
which will open a new dialog box.
In this example, "IN1" was selected to be
substituted by "CP1" and "IN2" will be substituted
by "CP2."
However, all sources such as Inputs, Scenes,
RamPlayers, Stills, Gfx, FxInputs, etc. are
selectable for substitution.
Picture 3.3.8.1.9
Enable/Disable effect
Picture 3.3.8.1.11
Picture 3.3.8.1.12
79