Panasonic KAIROS Operating Manual page 54

Picture 3.3.3.6.27
Inserting a "Counter" object allows use of some unique controls for this object type:
Picture 3.3.3.6.28
The "Clock" object type provides various modifications for appearance and run-directions:
Picture 3.3.3.6.29
The "WorldClock" object type can be modified to match various display-styles:
Note: For a better visualization the "Counter" & "Clocks" were composited into the displayed GUI images
(picture 3.3.3.6.28 / 3.3.3.6.29 / 3.3.3.6.31).
Within "GfxDropShadow Settings," the appearance of an enabled
Shadow can be adjusted. Apart from the Shadow-Color (with
Alpha-channel adjustment for transparency, see section "3.2.3
Color Adjustments" on page 22 in this manual), Angle,
Distance, and Softness controls are available. For adjustment,
use the sliders, the numeric entries, or up/down arrow controls.
Using the up/down arrows to adjust the Counter/Score. Also,
the commands "Increase (+1)," "Decrease (-1)," or "Reset
(=0) can be used in "Edit"-dialog for adjustments. Negative
results can be accomplished as well. Use "Increase,"
"Decrease," and "Reset (back to 0)" buttons in order to control
the "Counter" while in "Edit" mode.
The value
numbers/figures are used to display the Counter/Score.
The field "Start" is used to define the Clock-time to start with.
However, since the default "Direction" is set to count in the
"Up" direction, the "Start" field can also contain a time e.g.
30:00 minutes and "no hour," and start to count in the "Down"
direction (see picture 3.3.3.6.30 underneath). Use "Start,"
"Stop," and "Reset" buttons to control the "Clock" while in
"Edit" mode.
Use "Format" to describe the appearance of the "Clock":
%H = display Hours, %h = display Hour – no leading "0"
%M = display Minutes, %m = display Minutes – no leading "0"
%S = display Seconds, %s = display Seconds – no leading "0"
Picture 3.3.3.6.30
Click the "
and apply regional clock settings to be used to display.
Use "Format" to describe the appearance of the "Clock":
%H = display Hours, %h = display Hour – no leading "0"
%M = display Minutes, %m = display Minutes – no leading "0"
%S = display Seconds, %s = display Seconds – no leading "0"
%H or %h = used for 24h mode
%I or %i
%p = to add the "am" or "pm" flag to the displayed time
Picture 3.3.3.6.31
for "Digits" describes
In the "Direction" drop-down menu,
the run-direction can be adjusted in
order to count "Up" or "Down."
" symbol in the "Timezone" field in order to select
= used for 12h mode (replace "H" or "h" with "I" or "i")
This example shows the same
time, but is formatted in 12-hour
mode (no leading "0") and
displays the am/pm flag.
how many (1–8)
54