Table of Contents
Advertisement
1.
When the..engine-is cool, remove the
pressure .cap.
.Without pressing down on the
pressure cap, turn it slowly to the.
left .until.it reaches a "stop."
If
YOU
hear a hiss, it means there is
still some pressure. Wait for the
hiss to stop. Then press
down on
the pregsure- cap and continue
turning it
to
the left. Remove the
pressure cap.
2.
After the engine
cools, open the air
bleed valves on
the
throttle body and
water pump inlet.
3 . . fill with the proper mix. Add .coolant
until. you see a steady stream of.
coolant corning .frarn.the bleed vdves.
4,
Then close the bleed valves.
5.
Continue
to
fiH the coolant high .fill.
reservoir u.p to
the
base of the €iller
neck.
6.
Rinse or
wipe the spilled
crrolant
from the engine-and compartment.
7.
Start the engine-and
allow
it .to.run in
idkfor approximately four minutes.
By this time, the coolknt level inside
Advertisement
Table of Contents
