Chevrolet 1993 Corvette Owner's Manual page 133

. . I
Features &
Controls
Convertible Hardtop
(CONT.)
-3. Move both seats forward. Then slide
the lock pillar bracket into the
receiver bracket until the scribed line
is even with the lower edge of the
receiver bracket. Make-sure the black
wire. connectors are inside the vehicle
and
connected.
I
32
Insert the two upper Tarx@ bolts (C)
into both receiver brackets:. The
hardtop may have- to be lifted slightly
to install the lock pillar bracket.
A '
To help,avbid .p&oial
.
,.
,injury,,tighten all hardtop
.fasteners before driving the vehicle.
4.
If the hardtop hasn't lowered into
place, pull the release lever -behind
the driver3 seat.under the storage
compartment lid.
5.
Secure, but don't fully tighten, the
rear corner bracket bdts using the
flat ratchet wrench.
4