1.2 Brief Introduction To The Operating Environment; Figure 1-1 Electric Control Box T1 Simple Wiring Diagram - Delta DTV Series User Manual

Handheld Teach Pendant DTV Series User Manual

1.2 Brief Introduction to the Operating Environment

This section provides a brief description for the teach pendant only. For a complete description of the
operating environment, please refer to the control box manual.
•
The safety connector uses two sets of NC contacts for the emergency stop button, with the first set of
NC contacts connected to Pin 1 and Pin 2, and the second set of NC contacts connected to Pin 3 and
Pin 4. If the user has connected the safety gate signals to Pin 5, Pin 6, Pin 7, and Pin 8, functions
such as Jog, Goto, GoHome, and project program execution can be performed without pressing the
enable switch on the back of the teach pendant when the safety gate is closed. To perform teaching
with the teach pendant when the safety gate is open, the enable switch on the back of the teach
pendant must be pressed.
•
To create a simple jig for T1 mode, input 0V (connect the 0V pin of DC Output) for System DI/O Pin 1
and Pin 3. Please refer to the control box manual for details.

Figure 1-1 Electric control box T1 simple wiring diagram

14