Table of Contents
Advertisement
No.
Name
8
IO mapping
5.2
Introduction to the Software Interfaces
This section introduces the configuration of RTU-ECAT by taking the TwinCAT3 software as an example.
5.2.1 Main Interface for RTU Configuration
Click on the RTU-ECAT symbol on the left list of the TwinCAT3 window as below. The main RTU configuration
interface appears then.
5.2.2 DC Interface
On the RTU configuration interface, open the DC interface with a click on DC tab.
Operation Mode:
RTU-ECAT supports two operation modes, SM (Synchro Manager) and DC (Distributed Clock). Either of the
two operation modes can be chosen from the pull-down box.
Unit
The IO mapping between RTU-ECAT and the special modules
N/A
connected to it.
Chapter 5 Configuring RTU-ECAT
Explanation
5
5-3
Advertisement
Table of Contents
