Changing The Hydraulic Clutch Fluid - Husqvarna TC 250 2021 Owner's Manual

11.45

Changing the hydraulic clutch fluid

Warning
Skin irritation Brake fluid causes skin irritation.
–
Keep brake fluid out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
–
Consult a doctor immediately if brake fluid has been swallowed.
–
Rinse the affected area with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
–
If brake fluid spills on to your clothing, change the clothing.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and clutch lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
SERVICE WORK ON THE CHASSIS 11
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
–
Take off cover
S03439-10
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
Remove the protection cap.
–
Loosen bleeder screw
–
Mount bleeding syringe
F02287-10
1
.
2 3
with membrane .
4
with the appropriate hydraulic fluid.
p. 127)
5
.
4
on the clutch slave cylinder.
75