Husqvarna TC 250 2021 Owner's Manual page 89

Warning
Danger of accidents Brake linings which have not been approved alter the braking efficiency.
Not all brake linings are tested and approved for Husqvarna motorcycles. The structure and friction
coefficient of the brake linings, and thus their brake power, may vary greatly from that of original brake
linings.
If brake linings are used that differ from the original equipment, compliance with the original homolo-
gation is not guaranteed. In this case, the vehicle no longer corresponds to its condition at delivery
and the manufacturer warranty shall be void.
–
Only use brake linings approved and recommended by Husqvarna motorcycles.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
K01315-10
M01328-10
–
Stand the vehicle upright.
–
1
Remove screw cap with membrane
–
Manually press the brake caliper toward the brake disc to
push back the brake piston. Ensure that brake fluid does
not flow out of the brake fluid reservoir, if necessary extract
excess.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis-
ton.
–
3
Remove cotter pins , pull out pin
brake linings.
–
Clean the brake caliper and brake caliper bracket.
BRAKE SYSTEM 12
2
and the O-ring.
4
, and remove the
87