Cleaning, Care 17; Cleaning The Motorcycle - Husqvarna TC 250 2021 Owner's Manual

17.1

Cleaning the motorcycle

Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
–
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
–
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
60 cm (23.6 in)
–
Close off the exhaust system to keep water from entering.
–
Remove coarse dirt particles with a gentle water jet.
–
Spray heavily soiled parts with a normal commercial motorcy-
cle cleaner and then brush off with a soft brush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner
401061-01
and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle;
always rinse the vehicle with water first.
–
After rinsing the motorcycle with a gentle spray of water,
allow it to dry thoroughly.
–
Empty the carburetor float chamber.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Moisture and dirt impair the
brake system.
–
Brake carefully several times to dry out and
remove dirt from the brake linings and the brake
discs.
–
After cleaning, ride the vehicle a short distance until the
engine warms up.
Info
The heat produced causes water at inaccessible loca-
tions in the engine and on the brake system to evapo-
rate.

CLEANING, CARE 17

p. 129)
( p. 106)
113