Husqvarna TC 250 2021 Owner's Manual page 84

12 BRAKE SYSTEM
82
–
Remove cotter pins
brake linings.
–
Clean the brake caliper and brake caliper bracket.
–
Check that spring plate
7
plate in the brake caliper bracket are seated correctly.
100397-01
–
Insert the new brake linings, insert pin
4
cotter pins
Info
Always change the brake linings in pairs.
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
F00064-11
–
Add brake fluid up to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover
–
Mount and tighten screws
Info
Clean up overflowed or spilled brake fluid immediately
with water.
S03441-10
4 5
, pull out pin , and remove the
6
in the brake caliper and sliding
5
, and mount the
.
A
.
5 mm (0.2 in)
p. 127)
2 3
with membrane .
1
.