Copying Measurement Results; Transferring Data To "Repair Workshop; Transferring Data To "Entrance Check - Bosch TTM 2104 Original Instructions Manual

en | 56 | TTM 2104 / TTM 2204 | Vehicle data
9.2

Copying measurement results

In the "Test protocol" view, vehicle data can be linked
to a measurement results to the "Connected Repair" or
the "Entrance Check" service.
No. Screen Description
element
1 Button Data transfer to "Connected Repair"
"CoRe"
2 Button Data transfer to "Entrance Check"
"Entrance
Check"
|
1 691 206 005 2019-02-25
9.2.1

Transferring data to "Repair Workshop"

¶
Select button for transfer (no. 1).
i
The button is only active if the data has been saved
in the "Test protocol" view.
"
The data is transferred to "Connected Repair". If the
transfer has been successful, a green checkmark
appears. In case of errors, a red exclamation mark,
and an error message, if applicable, appears.
9.2.2

Transferring data to "Entrance Check"

¶
Select button for transfer (no. 2).
i
The button is only active if the data has been saved
in the "Test protocol" view.
"
The data is transferred to "Entrance Check". If the
transfer has been successful, a green checkmark
appears. In case of errors, a red exclamation mark,
and an error message, if applicable, appears.
Robert Bosch GmbH