Replacing Adsorbers - Bosch TTM 2104 Original Instructions Manual

Tire tread measurement device
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 32
en |
44 | TTM 2104 / TTM 2204 | Maintenance
Fig. 5:
Tighten screws on shear connectors
1 Screws/shear connectors
6. Re-adjusting support legs of both measuring units:
$
Loosen the lock between the threaded bolt and
two-hole nut.
$
Turn the threaded bolt using a hex key until the
cover plate rests equally on the frame and the leg
support.
$
Lock threaded bolt with two-hole nut.
Fig. 6:
Adjusting the leg support
1 Cover plate
2 Threaded bolt with two-hole nut
|
1 691 206 005
2019-02-25
Fig. 7:
Detail central support
1 Cover plate
2 Leg support
3 Hex nut SW27 M10
4 Two-hole nut
5 Threaded hole cover plate
6 Threaded bolt
7 Hex nut SW17 M10
7. Close cover plates.
8. Hinge drive-down ramps in measuring units.
7.2.4

Replacing adsorbers

1. Unhook drive-down ramps from measuring units:
to do so, lift both fillister head screws of the drive-
down ramps out of the measuring units' keyholes.
2. Open up the cover plates of the measuring units.
Cover plate stays open by itself after it has been
turned by approx. 110°.
3. Compare color of the drying agent with colors of the
drying agent label.
Robert Bosch GmbH

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ttm 2204

Table of Contents