Operating Time; Data Protection - Bosch TTM 2104 Original Instructions Manual

en | 52 | TTM 2104 / TTM 2204 | Software configuration
8.2.6

Operating time

Set the time and assign week days.
¶
Save changes with <Apply>.
i
If the TTM 2104 / TTM 2204 modules are always activated, it is
reasonable to limit the stand-by mode to the actual
daily usage. This increases the service life of the
device.
No. Screen Description
element
1 Schedule Select the schedule
2 Time Set the time
3 Week days Assign week days
8.2.7

Data protection

¶
Save changes with <Apply>.
No. Screen element Description
1 Protect access with Protect access with password:
password activate
2 New password Enter new password
3 Repeat Repeat new password
4 Delete Delete all registration numbers and
information
|
1 691 206 005 2019-02-25
i
Password is required when calling up the software.
Access to the software is only possible after the
password has been entered.
Forgot your password
If you forgot your password, the existing password can
be deleted by using the link "Forgot your password?"
and entering the administrator password. Due to
data protection reasons, also all stored vehicle data
(registration number, additional information) were
deleted.
Deleting registration numbers and information
All registration numbers automatically recorded via the
ANPR system as well as those entered manually on the
"Test protocol" page and additional information can be
deleted. Deleting the information must be confirmed by
entering the administrator password.
Robert Bosch GmbH