FujiFilm FM-DP L Service Manual page 156

INSTALLATION APPENDIX 1 SETTING, CONNECTING, ADJUSTING THE IMAGE I/F BOARD
<NOTES>
• For the video cable, its end marked as HOST should be connected to the
diagnostics unit.
• To connect in the order of HOST, monitor (CRT), and HAV90B board, the
termination select switch located on the CRT should be in the "no
termination" position.
To connect in the order of HOST, HAV90B board, and CRT, the
termination select switch located on the CRT should be in the "terminated"
position.
• The video cable for use with the HAV90B board is either 3 or 5 meters
long. Note, however, that if the pixel clock is 130MHz or higher, the 3
meter cable be used, and the 5 meter cable not be used.
(2) Connect the remote panel I/F cable to the connector (labeled PANEL on the
board retaining panel) of the HAV90B board.
(3) Connect the HOST auto-filming I/F cable to the connector (labeled HOST on
the board retaining panel) of the HAV90B board.
<NOTE>
The HOST auto-filming I/F cable should be connected only when the HOST
auto-filming specification is applicable.
There are two interface types: RS232C and RS422.
006-252-01
06.15.99 FM2514
FM-DP L Service Manual
BA1-23
BA1-23