Mstflint: Burning A Firmware Image - Nvidia MSTFLINT Manual

cache_image|ci
sign
set_public_keys [public key
binary file]
set_forbidden_versions
[forbidden versions]
binary_compare|bc
HW Access Key:
set_key [key]
hw_access <enable|
disable> [key]
Low Level Flash Operations:
hw query
e[rase] <addr>
rw <addr>
ww <addr> < data>
wwne <addr>
wb <data-file> <addr>
wbne <addr> <size> <data ...>
rb <addr> <size> [out-file]

The following commands are non-failsafe when performed on a 5th generation (Group II)
device: sg, smg, sv and set_vpd.

Manufacture GUIDs are similar to GUIDs. However, they are located in the protected area of
the flash and set during production. By default, firmware will use GUIDs unless specified
otherwise during production.

mstflint: Burning a Firmware Image

The mstflint utility enables you to burn the Flash from a binary image.To burn the entire Flash from a
raw binary image, use the following command line:
# mstflint -d <device> -i <fw-file> [-guid <GUID> | -guids
<MAC> | -macs <2
where:
Cache FW image (Windows only).
Sign firmware image file
Set Public Keys (For FS3/FS4 image only).
Set Forbidden Versions (For FS3/FS4 image only).
Verify the firmware image on a device which operates in livefish
mode by comparing it with an existing binary firmware file.
Set/Update the HW access key which is used to enable/disable access to
HW.
The key can be provided in the command line or interactively typed after
the command is given.
NOTE: The new key is activated only after the device is reset.
Enable/disable the access to the HW.
The key can be provided in the command line or interactively typed after
the command is given.
Query HW info and flash attributes.
Erase sector
Read one dword from flash
Write one dword to flash
Write one dword to flash without sector erase
Write a data block to flash
Write a data block to flash without sector erase
Read a data block from flash
MACs>] burn
<4 GUIDS> | -mac
54