Nvidia MSTFLINT Manual page 52

-i[mage] <image>
-log <log_file>
--low_cpu
-mac <MAC>1
-macs <MACs...>1
-no
-no_flash_verify
-nofs
-override_cache_repl
2
acement
-qq
-s[ilent]
-striped_image
-uid <UID>
-use_dev_rom
Binary image file.
Commands affected: burn, verify
Prints the burning status to the specified log file
When specified, cpu usage will be reduced. Run time might be increased
Commands affected: query
MAC address base value. 2 MACs are automatically assigned to the following
values:
mac -> port1
mac+1 -> port2
Commands affected: burn, sg
2 MACs must be specified here. The specified MACs are assigned to port1,
port2, respectively.
Commands affected: burn, sg
NOTE: -mac/-macs flags are applicable only for Mellanox Technologies
ethernet products.
Non interactive mode - assume answer "no" to all questions.
Commands affected: all
Do not verify each write on the flash.
Burns image in a non failsafe manner.
Allow accessing the flash even if the cache replacement mode is enabled.
NOTE: This flag is often referred to as -ocr
NOTE: This flag is intended for advanced users only. Running in this mode
may cause the firmware to hang.
Run a quick query. When specified, mstflint will not perform full image
integrity checks during the query operation. This may shorten execution time
when running over slow interfaces (e.g., I2C, MTUSB-1). Commands
affected: query
Do not print burn progress flyer. Commands affected: burn
Use this flag to indicate that the given image file is in a "striped image"
format.
Commands affected: query verify
5th Generation (Group II) devices only. Derive and set the device's base UID.
GUIDs and MACs are derived from the given base UID according to Mellanox
Methodologies.
Commands affected: burn, sg
Save the ROM which exists in the device (FS3 and FS4 image only).
Commands affected: burn
52